2A 스텝 모터 드라이버
(Stepper Driver 2 Ampere)
개요
- 본 제품은 unipolar(6선) 혹은 bipolar 스텝모터를 2A(피크시)까지 동작이 가능한 스텝모터 드라이버입니다.
- 모터를 연결하시 쉽게 터미널 블럭이 장착되어 있으며, 보드상에 테스트 버튼이 있어 연결을 검증할 수 있습니다.
- EN, DIR, Pulse의 전통적인 스텝모터 제어 신호와 함께 UART 시리얼 인터페이스가 있어 USB-Serial 어답터 등을 이용하면 PC에서 제어 또한 가능합니다.
특징
-
Support up to 1.8A (peak) per phase, 1A (continuous) per phase.
-
Microstepping:
-
Selectable via on board DIP switch
-
1, 2, 4 and 8 microstepping
-
-
Able to drive stepper motor from 6V to 20V
-
Single power source operation
-
5V logic level compatible inputs
-
Control input: Conventional: EN, DIR, PULSES; UART; Test button.
-
Maximum speed up to 1kHz of pulses (also depends on stepper motor's performance)
-
Bi-directional control
-
Enable/Disable pin for low power consumption mode.
-
No heatsink or fan required.
-
Comes with UART (serial) interface, control from computer is possible
-
UART baud rate are saved in the non-volatile flash memory (Factory default is baud rate = 9600)
-
By using the UART interface, user can:
-
On/Off, Run/Brake and change motor’s rotation direction
-
Set motor speed
-
Request for encoder value
-
Track an encoder value and brake the motor
-
Set new baud rate for the driver
-
Sample source code for UART control is provided!
-
- Dimension: 7.4 cm x 6.6 cm
문서
- User's Manual
- Sample code (PIC, Arduino, GUI)
- Fritzing file
연관제품
- 연관제품 1