3D 트레킹 및 제스쳐 센서 Flick Zero -라즈베리 제로용
(Flick Zero – 3D Tracking & Gesture pHAT for Raspberry Pi Zero)
개요
- 본 제품은 라즈베리 파이 제로와 사용이 가능한 3D 트레킹 및 제스쳐 센서입니다.
- 15cm 거리까지에서 제스쳐를 검출할 수 있으며, 원을 그리거나 손을 옆으로 미는 동작 등을 트레킹할 수 있습니다.
- 근접 자기장을 이용하기 때문에 나무나 아크릴과 같은 재질 뒤에서도 센싱이 가능합니다(거리는 줄어들수 있음)
- 제스쳐를 이용하여 장치를 제어하여 보세요.
특징
-
Fully compatible with Pi Zero & Pi Zero W
-
Also works with Raspberry Pi A+, B+, 2B, 3B and all other Raspberry Pis with 40 GPIO pins (or compatible boards).
-
3D tracking
-
Gesture sensing up to 15cm
-
Touch and Tap sensing
-
Communicates with the Raspberry Pi via I2C
-
Full software libraries (fully open-source code)
-
One-line installer
-
No soldering required
-
Dimensions: 6.5cm x 3cm x 0.6cm
-
Fully CE and FCC tested and approved
-
Chip: MGC3130 3D Tracking and Gesture Controller
-
Detection range: 0 to 15 cm in ideal circumstances
-
Temperature Range: -20℃ to +85℃
-
Position Rate: 200 positions/sec
-
Spatial Resolution: up to 150 dpi
-
Proximity and Touch Sensing
-
Flick Large has a red/green dual RGB LED that can be driven using pins LED1 and LED2
-
Flick Large has level shifting on board so can work with any microcontroller with either 5V or 3V3 power and data signals
-
Compatible with the Hillstar Development Kit over USB on PC in order to use with a computer or to program new firmware onto the board.
-
Available gestures: Swipe (east to west, west to east, north to south, south to north), tap and double tap (center, east, west, north, south), airwheel (clockwise, anti-clockwise) and touch (center, east, west, north, south)
-
Works even through the Flick Large case
-
No detection blind spots
-
Low–power design
-
Technical Details
Dimensions 130mm x 75mm x 25mm Weight G.W 50g Battery Exclude Part List
Flick Zero 1 Plastic bolts 8 Plastic spacers 4 Stickers 3 Info card 2