공기품질 가스 센서 -ZMOD4510
(AIR QUALITY 8 CLICK)
개요
- 본 제품은 공기품질 가스 센서 -ZMOD4510입니다.
- ZMOD4510 디지털 가스 센서를 장착하고 있어 이산화질소, 오존과 같은 가스를 측정할 수 있습니다.
- i2C 인터페이스를 가지고 있습니다.
특징
-
HOW DOES IT WORK?
Air quality 8 Click as its foundation uses the ZMOD4510, a pre-calibrated digital sensor designed for reliable indoor and outdoor air quality detection from Renesas. This sensor comes with selective ozone measurement capabilities (NO2 and O3) and allows improved energy efficiency with less than 23mW of power consumption in continuous operation without compromising air quality. It also features electrical and gas calibration, proven MOx material, digital interface, siloxane resistance, and high-sensitivity and long-term stability allowing ppb detection limits. It covers extended operating humidity and temperature ranges from 5 to 90%RH and from -20°C to 50°C with ozone and nitrogen dioxide measurement ranges from 20 up to 500ppb.
The ZMOD4510 has a gas-sense element, consisting of a heater element on a silicon-based MEMS structure, a metal-oxide (MOx) chemiresistor, and a CMOS signal conditioning IC that controls the sensor temperature and measures the MOx resistance, which is a function of the gas concentration. It has two operational modes. The first mode of operation allows a general measurement of Air Quality, including the non-selective measurement of nitrogen dioxide (NO2) and ozone (O3). The second mode of operation allows the selective measurement of ozone (O3) featuring Ultra-Low Power with an average consumption of 0.2mW during its fast sample rate of 2 seconds.
It detects typical gases based on studies and international standards for outdoor air quality and uses a sequence of applied temperatures to sample the air and report an Air Quality Index (AQI). The sensor does not require an active or direct airflow onto the sensor module because diffusion of ambient gas does not limit the sensor response time. The ZMOD4510 can also detect safety-relevant gases; however, the sensor module is not designed to detect these interferants reliably. Therefore, it is not approved for use in any safety-critical or life-protecting applications.
Air quality 8 Click communicates with MCU using the standard I2C 2-Wire interface to read data and configure settings, supporting Standard Mode operation with a clock frequency of 100kHz and Fast Mode up to 400kHz. In addition, it also possesses other features such as reset pin routed to the RST pin on the mikroBUS™ socket, which with a low logic level puts the module into a Reset state, an additional interrupt signal, routed on the INT pin of the mikroBUS™ socket labeled as INT, indicating the status of measurement process itself.
This Click board™ can be operated only with a 3.3V logic voltage level. The board must perform appropriate logic voltage level conversion before use with MCUs with different logic levels. However, the Click board™ comes equipped with a library containing functions and an example code that can be used, as a reference, for further development.
-
Type Air Quality ,Gas Applications Can be used for detecting unhealthy conditions in outdoor air, such as personal air-quality monitor, HVAC, and other various air quality-related applications On-board modules ZMOD4510 - pre-calibrated digital sensor designed for reliable indoor and outdoor air quality detection from Renesas Key Features Pre-calibrated, reliable for outdoor and indoor air quality detection, low power consumption, MOx material, digital I2C output, siloxane resistance, high-sensitivity, long term stability, and more Interface I2C Compatibility mikroBUS Click board size S (28.6 x 25.4 mm) Input Voltage 3.3V