네오픽셀 1/4 60링
-WS2812 5050 RGB LED, 드라이버 내장
(NeoPixel 1/4 60 Ring
- WS2812 5050 RGB LED w/ Integrated Drivers)
개요
- 본 제품은 네오픽셀 링입니다. 본 제품 4개를 이용하여 60개의 LED가 장착된 네오픽셀링을 구성할 수 있습니다.
- 본 제품 4개를 납땜하여 붙이면 약 6.2인치 지름의 링이 완성됩니다.
- 링은 chainable하기 때문에 한쪽의 출력을 다른 한쪽의 입력에 연결하며, 하나의 마이크로컨트롤러만을 사용하여 제어합니다.
- 각각의 LED는 드라이버를 내장하고 있어 개별적으로 주소연산이 가능합니다.
- 각 LED는 18mA이하의 동작 전류를 가지고 있어 전압이 변하더라도 안정적으로 컬러를 유지할 수 있습니다.
- 외부 choke 저항은 필요 없으며, 5VDC 전원을 이용하여 전체 LED에 전원을 공급할 수 있습니다.
- LED는 매우 timing-specific한 프로토콜을 사용하므로, AVR, Arduino, PIC, mbed와 같은 실시간 마이크로컨트롤러를 사용하여야 하며, 인터프리터 기반이나 리눅스 기반의 마이크로컨트롤러는 사용할 수 없습니다.
- 네오픽셀 라이브러리를 이용하여 본 링을 제어할 수 있습니다.
- 동작을 위해서는 8Mhz 혹은 그 이상으로 빠른 프로세서가 요구됩니다.
- 본 제품에는 15개의 RGB LED가 장착되어 있습니다. 링의 구성을 위해서는 4개의 제품이 필요합니다.
특징
- Outer Diameter of Full Circle (four put together): 6.2"
- Inner Diameter of Full Circle (four put together) 5.7"
- Width of individual section: 6.4mm/0.25"
- Height: 2mm/0.1"
- Weight of individual section: 4.03g
- We currently ship this product with the WS2812B 4-pin chip LED installed. Previous versions may have come with the WS2812S 6-pin LED. Both B and S LEDs can be chained together and are compatible with the NeoPixel Libary. The 'B chip type adds additional polarity protection and is the same brightness as the 'S type.
- When soldering these together, line up the four pieces and connect all the GND and 5V pins together as shown above. Then forthree out of the four pieces solder DIN to DOUT. The remaining DIN is the input pin for the entire ring.