Zybo Zynq-7000 ARM/FPGA 개발보드
(Zybo Zynq-7000 ARM/FPGA SoC Trainer Board [Digilent])
개요
- Zybo (Zynq™ Board)는 풍부한 기능을 가졌으면서 사용하기 쉬운 엔트리 레벨 임베디드 소프트웨어 및 디지털 회로 개발 플랫폼으로 Z-7010을 탑재한 제품입니다.
- Xilinx사의 AP SoC(All Programmable System-on-Chip) 기반의 Z-7010은 듀얼 코어 ARM Cortex-A9 프로세서와 Xilinx 7 시리즈 FPGA 로직을 통합한 칩입니다.
- 보드상의 메모리, 비디오, 오디오 I/O, 듀얼 롤 USB, 이더넷, SD 슬롯이 있어 추가적인 하드웨어 없이 바로 디자인을 시작할 수 있게 하여 줍니다.
- 추가적으로 여섯개의 Pmod 커넥터가 있어 추가적인 모듈을 장착할 수 있습니다.
- Zybo는 Xinlix의 Vivado Design suite 및 ISE/EDK 툴셋과 호환됩니다.
- 이 툴셋들은 FPGA 로직 디자인을 embedded ARM 소프트웨어 개발에 녹여내 사용하기 쉽고 직관적인 디자인 흐름을 보여줍니다.
- 본 제품을 이용하여 어떤 것부터 시작하여야 할지 모르시겠다면 무료로 다운로드 가능한 Zynq Book을 참고하여 보십시오.
특징
- Xilinx Zynq-7000 (XC7Z010-1CLG400C)
- 28,000 logic cells
- 240 KB Block RAM
- 80 DSP slices
- On-chip dual channel, 12-bit, 1 MSPS analog-to-digital converter (XADC)
- 650 MHz dual-core Cortex™-A9 processor
- On-board JTAG programming and UART to USB converter
- DDR3 memory controller with 8 DMA channels
- 512 MB x32 DDR3 w/ 1050Mbps bandwidth
- 128 Mb Serial Flash w/ QSPI interface
- microSD slot (supports Linux file system)
- High-bandwith peripheral controllers: 1G Ethernet, USB 2.0, SDIO
- Low-bandwidth peripheral controller: SPI, UART, I2C
- Dual-role (Source/Sink) HDMI port
- 16-bits per pixel VGA output port
- Trimode (1Gbit/100Mbit/10Mbit) Ethernet PHY
- OTG USB 2.0 PHY (supports host and device)
- External EEPROM (programmed with 48-bit globally unique EUI-48/64™ compatible identifier)
- Audio codec with headphone out, microphone and line in jacks
- GPIO: 6 pushbuttons, 4 slide switches, 5 LEDs
- Six Pmod connectors (1 processor-dedicated, 1 dual analog/digital)
- Note: The Zybo ships without accessories.