스퀘어 웨이브 신호 생성기 -NE555
(Square Wave Signal Generator -NE555)
개요
- 본 제품은 스퀘어 웨이브 신호를 생성할 수 있는 신호생성 모듈입니다.
- 실험적인 개발 용도나 스텝모터를 동작시키는 어플리케이션이나 마이크로컨트롤러 어플리케이션을 위한 펄스 조절용으로 사용이 가능합니다.
- NE555 타이머 칩이 탑재되어 있으며, 4개의 주파수 범위(보드상 점퍼로 설정)에서 사용 가능하게 디자인 되었습니다.
- 출력 주파수와 듀티 사이클은 장착된 두개의 트림 포텐셔미터로 조절이 가능합니다.
- 모듈의 입력전압은 5-15VDC이며 약 15mA@5V(35mA@12V)를 소비합니다.
특징
- Size: 3.1CM * 2.2CM
- the main chip: NE555;
- Input voltage: 5V-15VDC. When 5V supply, the output current can be at around 15MA; when the 12V supply, the output current can be about 35MA;
- the input current: ≥ 100MA
- the output amplitude:. 4.2V V-PP to 11.4V V-PP (different depending on the input voltage, the output amplitude will be different)
- the maximum output current: ≥ 15MA (5V power supply, V-PP greater than 50%), ≥ 35MA (12V power supply, V-PP greater than 50%)
- Output with LED indication, there is no output straightforward (LOW LED quantity, high LED off, LED blink rate is relatively low);
- The output frequency range of grades available, the output frequency more continuously adjustable;
- LF file: 1Hz ~ 50Hz
- IF file: 50Hz ~ 1kHz
- High frequency file: 1KHz ~ 10kHz
- High-frequency file: 10kHz ~ 200kHz
- You can fine-tune the output duty cycle, duty cycle and frequency are not adjustable, adjust the duty cycle will change the frequency
- The output frequency is adjustable: Cycle T = 0.7 (RA +2 RB) C
- RA, RB is 0-10K adjustable;
- At low frequencies file C = 0.001UF;
- Medium frequency when C = 0.1UF;
- High frequency file C = 1UF;
- When high-frequency gear C = 100UF, so the frequency of the waveform buyers can own calculations
문서
연관제품
- 연관제품 1